Canon DR-7080C - Manual (Page 30)

26
Chapter 2 Connecting to a Computer
CAUTION
◆ Connecting the SCSI Cable
■ The SCSI cable should only be as long as the rating for the SCSI card being used. If
the SCSI cable is longer than the rated length, the scanner may not operate correctly.
■ Before you connect the SCSI cable, make sure that the scanner and the computer
are turned OFF.
■ Do not connect both SCSI and USB interface cables at the same time.
Connect your computer to the scanner using the SCSI cable.
Two SCSI connectors are located on the rear of the scanner. Insert the SCSI
cable from the computer into one of the connectors on the bottom of the scanner.
To connect another SCSI device to the computer, insert the other SCSI cable into
the vacant SCSI connector on the rear of the scanner, and connect the other end
of the SCSI cable into the SCSI device in a daisy chain.
SCSI Connectors
(Cannot be used at the
same time a USB
connector is in use.) USB Connector
◆ Setting the SCSI ID and Terminator
Set the SCSI ID and the terminator on the DIP switches located between the
SCSI connectors and the USB connector.
Move the DIP switch up to turn it OFF and move it down to turn it ON.
SCSI ID Terminator
SCSI ID
0
1
2
3
4
5
6
7
SW1
OFF
ON
OFF
ON
OFF
ON
OFF
ON
SW2
OFF
OFF
ON
ON
OFF
OFF
ON
ON
SW3
OFF
OFF
OFF
OFF
ON
ON
ON
ON
Set the SCSI ID referring to the table above.
Set unique SCSI IDs to any other built-in SCSI devices or SCSI devices
connected to the computer.