FaxBack AudioCodes Mediant 1000 - Configuration Guide - Manual (Page 10)

AudioCodes Mediant 1000 Configuration Guide — Page 10
FXO Configuration
Configuration > Protocol Configuration > Endpoint Settings > Automatic Dialing
NOTE: Do not configure automatic dialing for FXS ports; this will prevent you from faxing to any number but the
“Destination Phone Number.”
If you are receiving DTMF tones from a PBX on the FXO lines, it is not strictly necessary to configure automatic dialing. It is
recommended to configure automatic dialing so that the call is not lost if the PBX fails to send DTMF tones. For each FXO port,
enter the port’s corresponding phone number in the “Destination Phone Number” field. Set “Auto Dial Status” to “Hotline.”
If you are not receiving DTMF tones, you will need to configure a fixed phone number for each FXO port. Enter the port’s
corresponding phone number in the “Destination Phone Number” field. Set “Auto Dial Status” to “Enable.”
Click “Submit” when you are done. Click “Burn” at the top of the page.
Configuration > Advanced Applications > FXO Settings
Dialing Mode One Stage
Configuration > Protocol Configuration > Protocol Definition > DTMF & Dialing
This controls DTMF collection on both FXO (inbound dial) and FXS (outbound dial) ports. If you are not using FXS ports,
and are doing DTMF collection on the FXO ports, then you can decrease the values here to slightly decrease call times.
For example, if you are collecting 4 digits on the FXO ports, try these timings:
Max Digits in Phone Num 4
Inter Digit Timeout for Overlap Dialing 1
Hotline Dial Tone Duration 2
Test after making any changes to verify all DTMF digits are still being captured.
Burn Configuration Changes
IMPORTANT: Click the “Burn” button at the top of the page so that the configuration will be permanently saved to flash
memory. If you do not click “Burn,” any changes you made will be lost when the device reboots.