FaxBack Mediant 1000 Appliance - Installation Guide - Manual (Page 7)

AudioCodes Mediant 1000 Installation Guide — Page 7
If you are using any FXS ports, first we need to route their DIDs to your FMIS server. Create one entry per FXS port:
Dest. Phone Prefix The port’s “Phone Number” that was assigned on the Trunk Group page.
Source Phone Prefix *
Dest. IP Address The IP address of the FMIS server
IP Profile ID 0
After all FXS port entries, create one entry that will route everything else to the fax server:
Dest. Phone Prefix *
Source Phone Prefix *
Dest. IP Address The IP address of the fax server
IP Profile ID 0
Click “Submit” when you are done. Click “Burn” at the top of the page.
Routing Table – IP to Trunk Group
Configuration > Protocol Configuration > Routing Tables > IP to Trunk Group Routing
This page allows you to route calls from IP addresses to the telephony interfaces on the device. The following screen shot is an
example only, your hardware will need a different configuration. Read below for details.
Create one entry:
Dest. Phone Prefix *
Source Phone Prefix *
Source IP Address The IP address of the fax server
Trunk Group ID 1
IP Profile ID 0
If you are using an FMIS, create another entry:
Dest. Phone Prefix *
Source Phone Prefix *
Source IP Address The IP address of the FMIS server
Trunk Group ID 2
IP Profile ID 0
Click “Submit” when you are done. Click “Burn” at the top of the page.