Sangean U3 (V1) - Manual (Page 10)

9
Operating the radio
This radio is equipped with three tuning methods – Scan tuning,
Manual tuning and Memory presets recall.
Scan Tuning
. Press the Power button to turn on the radio.
2. Select the required waveband by pressing the Band button.
For FM band, be sure to screw in the rubber FM antenna properly
to get best reception. For MW (AM) band, rotate the radio to get
best signal.
3. Press and release Tuning Control /Time Set /Scan knob (long
press the knob more than 2 seconds will activate time setting),
the radio will up search and stop automatically when it finds a
radio station. Press the Scan button again to pick up the found
station.
Note:
The radio will continue to search next available stations if you do
not press Scan button again when it finds a radio station.
4. Rotate the Volume Control and Tone Control to get required
sound level.
5. To turn off the radio, press the Power button.
Display will show OFF.