Sangean U3 (V1) - Manual (Page 12)


Recalling stations from preset memories
. Press the Power button to turn on the radio.
2. Select the required waveband.
3. Momentarily press the required Preset button, the preset number
and station frequency will appear in the display.
Setting the radio alarm
When the radio alarm is selected, the radio will turn on and play the
chosen radio station at the chosen alarm time. The radio alarm will
continue for one hour unless turned off by pressing the Power but-
ton. Press the Power button whilst the alarm is activated will cancel
the alarm for 24 hours.
Note:
Radio alarm can be activated only until both radio alarm time and
radio alarmed station are set. Radio alarm will be automatically
switched to Buzzer alarm when the radio is in low battery status or
the selected radio alarm station signal is too weak.
a. Setting radio alarm time:
. The radio alarm can be set either radio is on or off.
2. Press and release radio alarm button , the radio alarm symbol
will flash.
3. During radio alarm flashing, press Tuning control/Scan/Time Set
knob for more than 2 seconds followed by a beep tone.