Sangean U3 (V1) - Manual (Page 13)

2
GB
4. Display Hour will flash, rotate Tuning Control knob to select the
hour then press in Tuning control/Scan/Time Set knob again to
confirm hour setting.
5. Follow same procedure of setting hour to set required minute.
Press Tuning Control/Scan/Time Set knob again to complete
alarm time setting.
b. Setting radio alarmed station:
1. During setting radio alarm time and radio alarm symbol is flashing,
press Band button to activate the radio to select required wake-up
band and station by manual tuning and recall preset stations.
2. When above radio alarm time and station are set, press and hold
radio button for 2 seconds followed by a beep tone to switched
alarm on or off. Display will show when radio alarm is set.
Note:
If new radio alarm station is not selected, it will select the last
alarm station.