Sangean U3 (V1) - Manual (Page 8)

7
1. Battery operation
Installing the batteries, first turn battery cover fixture anti-clockwise
to loosen and put down the battery cover. Insert 6 x D size (UM-1)
battery into the compartment. Ensure the battery is inserted in ac-
cordance with the diagram shown.
Close the battery cover and fasten the fixture by turning clockwise.
If the radio is not to be used for any extended period of time, it is
recommended that the battery is removed from the radio.
2. AC operation
Before you plug the AC cord into the AC socket, be sure the volt-
age is correct. If you have batteries in the radio and use the AC
power cord, the batteries will automatically be disconnected.
Switch the “Open“ to the AC cord compartment to OPEN position,
pull back the compartment door and cylinder of the AC cord stor-
age, put out the AC cord to get the required length to the AC socket
and position the AC cord in the cut out in the lower right side of the
compartment door. Close the door.
You can store the AC cord after use in the opposite way you pull
out the AC cord.
3. Powered via DC IN socket
The radio can be also powered via the DC IN socket which can al-
low 9-4 Volt DC, which is designed to be powered by the vehicle
or the boat so you can take the radio with you outdoors or on the
boat.
An additional cigarette lighter cable is required (not supplied) for
this device.