Sangean U3 (V1) - Manual (Page 11)

0
GB
Manual tuning
. Press the Power button to turn on the radio.
2. Select the required waveband by pressing the Band button.
Adjust the antenna as described above.
3. A single press on either rotate the Tuning Control knob will change
the frequency in the following increments:
FM: 50 or 100 kHz
MW (AM): 9 or 10 kHz
4. Rotate the Volume Control and Tone Control to get required
sound level.
5. To turn off the radio, press the Power button.
Display will show OFF.
Storing stations in preset memories
There are 5 memory presets for each waveband.
. Press the Power button to turn on the radio.
2. Tune to required station using one of the methods previously
described.
3. Press and hold down the required preset until the radio beeps.
The preset number will appear in the display and the station will
be stored under chosen preset button.
4. Repeat this procedure for the remaining presets.
5. Stations stored in preset memories can be overwritten by following
above procedures.