CANOGA PERKINS 9101 LAN Chassis - Manual (Page 13)

13
9101 LAN Chassis Canoga Perkins
Chapter 3 - Module Installation
3.1 8814 Fiber Optic Transceiver
Once the 9101 LAN Chassis is installed, the 8814 Fiber Optic Transceivers may be
cabled and inserted into the chassis.
Step 1 First, note that the orientation of the 8814 Fiber Optic Transceiver is
intended such that the LED indicators on its front panel face out, with
cable connections made from the rear. Next, run the AUI cable from the
DTE device to the back of the LAN chassis and over the rear cable guide
(spring-like metal) to the back of the transceiver. Then attach the AUI
cable to the transceiver while it is out of the LAN chassis.
Step 2 Attach the appropriate fiber optic cables to the transceiver. As with the
AUI cables, connections should be made with the unit out of the chassis
(see Figure 3-1).
Figure 3-1
8814 Fiber Optic Transceiver
and Cable Connections