CANOGA PERKINS 9101 LAN Chassis - Manual (Page 25)

25
9101 LAN Chassis Canoga Perkins
Figure 4-4
Replace Power Supply - Step 4
Figure 4-3
Replace Power Supply - Step 3
Step 4: After you have removed the faulty P/S, set the replacement on the chassis
where the defective one was removed. Note the slot on the back end of
the P/S. This is the guide slot that will fit around the raised tab that makes
up the back of the P/S guide. The P/S guide is located along the side of
the chassis on which the power supply will rest. Reference Figure 4-4.