Leica Geosystems Laser Locator - Manual (Page 6)

6 Laser Locator-1.0 en
Getting started Changing the battery
i
Getting started
Open the battery compartment
using a suitable tool, or a coin.
Insert a 6V lithium battery,
SANYO type 2CR5 or equivalent.
Ensure that the drawing ribbon
lies above the securing tape of
the battery cover. Keep the
battery cover seals and the
instrument case clean. Refit the battery cover and re-
tighten the screw.
The Laser Locator monitors the
battery’s condition. If the display
shows ”LobAtt”, this indicates
that the battery is used up. You
can still get readings, but the
battery needs to be replaced
soon.
The ”LobAtt” display may also
appear under cold conditions,
since low temperature reduces
the battery performance.
Remove the Laser Locator
battery before a prolonged
period of non-use.