Panasonic WJ-MX30 - Manual (Page 15)

OPERATION
A. Pre-Operational Setup
A-1. Power ................. Field Preset Operation mode
1. Press the MAIN POWER Switch (98) on located on the
rear panel. The unit is now in stand-by mode. No
operations can be executed yet.
2
.
Notes :
• When turning off te MAIN POWER Switch with
the POWER switch ’’OFF", this unit is stand-by
condition by turning on the MAIN POWER switch.
• When turning off the MAIN POWER switch with the
POWER switch ”ON’’, this unit is on condition by
turning on the MAIN POWER switch if the memory
backup is kept.
In this time, if the memory backup is not kept, this
unit is stand-by mode.
Press the Power On/Off Button (1) on the operation
panel. The unit is now in operation mode and the
Cooling Fan (97) located on the rear panel starts to
rotate. The LED’s on the operation panel light up as
shown below.
Notes :
1. If you do not use the unit for an extend period of
time or to shut off the power completely, switch
off the MAIN POWER Switch (98).
2. If the Cooling Fan (97) does not rotate, switch it off
and disconnect the AC power cord. Call service
personnel before attempting further use.
3. The modes selected by buttons will be kept by
memory backup approximately 1 week even if AC
power is disconnected.
A-2. Reset ...............Factory Preset Operation mode
Press the Power On/Off Button (1) off. With both the Color-A
(49) and B (50) Buttons depressed, press the Power On/Off
Button (1) on.
It would be helpful in case of unexpected operational failure.
B '
D
3. And this status, without still and strobe, is later recalled
when the power is restored if the memory is kept.
- 13 -