Panasonic WJ-MX30 - Manual (Page 18)

If the CHROMA Control (47) is turned fully to the
MIN position and the position of the R/G/B Control
(46) to the center, a Black and White video image
is obtained. When adjusting the R/G/B Control (46)
from this position, a mono tone (R/G/B) video image is
obtained.
Notes :
1. A Black and White video image may be obtained
in another way. Press the Color-A Button (49) or
Color-B (50) Button once (The LED blinks). Turn
the CHROMA Control (47) fully to MIN position.
2. When pressing the Color Correction Button to turn
on while turning on the Position On/Off Button, the
LED on the Position On/Off Button blinks for the
stnad-by mode, the positioning scene is kept and
the color correction is available.
B-5. Position Control
The position of a specific wipe pattern can be changed
on the monitor screen using Position Control function.
C. Basic Operation 2
Digital Effect block
The following is a detailed description of the Digital Effect
block function which generates digital special effects for
the A-bus and B-bus source video signals. In order to add
the desired effect(s) to the A-bus (B-bus) signal, press the
A-Button (21) (B-Button (22)) and the ON-Button (20).
□i
a
□
Q S D]P P
Q n
Notes :
Press the Square Wipe Button (13) and select the
desired wipe pattern by pressing this button repeatedly.
Press the Position On/Off Button (45) on. The LED on
this button lights. (Wipe size is doubled.)
Adjust the Mix/Wipe Lever (58) to obtain the desired
wipe size.
Operate the Positioner Joystick (46). The position of a
wipe scene can be changed on the monitor screen.
Note :
When pressing the Position On/Off Button to turn
on while turning on the Color Correction On/Off
Button, the LED on the Color Correction On/Off
Button blinks for the stand-by mode and the
corrected color scene is kept and position control
is available.
1
.
2 .
The selected effect(s) can be added to either the A-bus
or B-bus at one time.
Without pressing the Effect On/Off Button (20), the
digital effect(s) will not added to the A-bus or B-bus
signal.
Negative
Press the NEGA Button (25). A negative image (like a
film negative) is obtained. Color correction can also be
used with this function.
Normal Image Negative Image
MOSAIC
Press the MOSAIC Button once (24). A mosaic-like or
box-like pattern is obtained. Mosaic pattern size can
be adjusted continuously at 31 steps with SIZE Control
(23).
■
i
L ^
♦
Normal Image
- 16 -