Panasonic WJ-MX30 - Manual (Page 30)

INTERFACE
1. GPI (General Purpose Interface)
The Auto Take function is activated at the point of the
following edge of the GPI pulse .
Conversion Cable information
Make the required conversion
following wiring information.
cable referring to the
Pre-roll A/B
GPI
WJ-MX30
1
No.1 (A-bus)
Transition 0
(MIN)
No.2 (B-bus)
Transition Time
(No.2)
GPI 1.
When the above signal is used as a GPI signal, follow the
procedure shown below.
1. Select the video signal of A-roll for the A-bus signal
and the video signal of B-roll for the B-bus signal.
2. Set the Wipe/Mix Lever to the A-bus position.
3. Set the video signal of the A/B - roll to the desired
pattern (Mix/Wipe, Wipe Pattern or the like)
4. Set the Auto Fade/Take Transition Control to the 0
position.
5. Store this condition in Event Number Button 1.
6. Set the Wipe/Mix Lever to the B-bus position and
adjust the Auto Fade/Take Transition Control to the
desired interval.
7. Store this condition to Event Number Button 2.
8. Press the RECALL Button and then Event Number
Button 1.
Editing is made with the Event Number 1 condition (A-roll)
at the point of the pre-roll.
The A/B-roll is activated at its point with the transition time
stored in the Event Number 2.
Event Memory Functions
The following set can be stored by the Event Memory
Functions.
1. Setting of the all buttons.
2. Setting of the following controls.
• Transition time
•
Position
• Color correction level
•
Mosaic size
• Key level
The Event Memory Functions can be activated by pressing
Auto Take Button.
RS-232C WJ-■MX30
25-pin 9-pin
2 TXD 1 SPARE
3 RXD 2 RXD
4 RTS 3 TXD
5 CTS 4 DTR
6 DSR 5 SIG.G
7 SIG. G 7 SIG.G
20 DTR 8 RTS
9 SPARE
(DCE CONNECTION)
Refer to the table below for the transmitting protocol in
connecting the RS-232C to the DT/WJ-MX30.
1 BAUD RATE 9600 bps
2 CHAR SIZE 7 bits
3 PARITY Odd
4 STOP BIT 1 bit
5 FLCTRL RTS/CTS
Note :
Be sure to supply the signals for the RS-232C
according to the above table.
- 28 -