Panasonic CQ-VX999EW - Manual (Page 12)

Bass Emphasis/SBC (Super Bass Control)
The SBC function reinforces the bass range to suit the speaker characteristics.
® It is set to the rear speaker output, and permits selection of any of the three positions depending on the
type of speakers installed. (See the table below.) These characteristics are so set as to be best suited
particularly to the recommended speakers, but are subject to change in acoustic effects depending on
the type of car and the speakers' positions.
® Referring to the characteristics of each type of speaker, set SBC as suited to the characteristics of the
type of speakers used, in case of the SBC-SW type, the system can be upgraded by connecting a
desired sub-woofer to the special sub-woofer output to create a front-oriented sound.
Setting a SBC Type
® Press SELECT to select SBC mode.
@ Press A to set SBC.
(When "SBC" is not displayed.)
d) Setting a type
Press ^ to switch the SBC type in sequence as follows.
(SBC default: SBC OFF)
OPERATION: GENERAL
(Continued)
SBC OFF
X
SBC TYPE 1
SBC TYPE 2
SBC TYPES
Normal. To reproduce normal,-
flat characteristics
Bass is reproduced for easier
listening by cutting off its
undesired components accord­
ing to the characteristics of the
sub-woofer built in the amplifier.
Bass is emphasized according
to the characteristics of the
semi-flushed mounted speaker.
Bass is emphasized according
to the characteristics of the
flushed mounted speaker. —
Set the SBC type
dependent on
■speakers used.
(See the following
speakers
assumed.)
(H^ : opposite direction)
SBC Display Speaker Assumed
SBC TYPE1
Semi-flush mounted speaker
SBC TYPE2
SBC TYPES Flush mounted speaker
12
CQ-VX999EW