Panasonic CQ-VX999EW - Manual (Page 5)

TILT MOVEMENT
Starting Operation / Power
ir' Turn the ACC switch of your car to ON,
(2 Press any ofT (TUNER), © (CD), g) (TAPE), ^
or D ® M, and your unit is switched on.
(CH * C)
Note:
When you are using your unit for the first time, the demonstration
mode pattern is displayed. The display may remain unchanged
when the above buttons are pressed, in such a case, press
DISP to release demonstration mode.
Caution:
If there is any obstacle above the mounting position in your
car, set your unit at HALF 1, HALF 2 or HALF 3 as shown at
left.
The front panel is originally set to the position (FULL OPEN).
See page 40 for how to set the front panel to lift-up position.
Front Panel Angie Adjustment
(Tilt)
® The front panel can be adjusted to a desired angle for easy display
viewing or easy button operation.
® The front panel angle changes in 3 steps each time press and hold
TILT for more than 0.5 second as shown at left.
® Even after turning off the power, the last TILT angle is memorized.
Note:
® When the engine is turned off, the front panel is automatically
fully closed.
® The front panel goes down if a button on it, for example, is
pushed hard after adjusting the angle. It automatically returns
to the original position after that.
Caution:
Never put your hand or finger inside while the front panel is
opening or closing. This is important to avoid injuries.
Never push or pull the front panel, or expose it to shock while
it is opening or closing, or when it is up highest. This is
important to avoid trouble.
Do not place anything on the front panel while it is opening or
closing, or when it is up highest.
CQ-VX999EW