Panasonic CQ-VX999EW - Manual (Page 46)

Installation Guide
■ Precautions
if possible, this equipment should be professionally installed. In case of difficulty, please consult with your
nearest professional installer.
1. This unit only operates in a 12-volt DC negative ground system.
2. Before performing installation and wiring, remove the negative (~) terminal of the battery.
(See Note beiow.)
Mote:
Do not disconnect the negative battery terminal in vehicles equipped with trip or navigational
computers. All electronic memory settings previously registered will be lost. Take extra care to avoid
causing short-circuits when installing the unit.
3. Follow the wiring connection diagram carefully to avoid causing damage to the unit.
4. Insulate all exposed wires to prevent short-circuits.
5. Secure ail loose wires after installing the unit.
6. Please carefully read the operating and installation instructions of any equipment connected to this unit.
■ Transportation bracket removal
Be sure to remove the bracket for transportation before use (installation).
TipUse sdrews (M5 x 8 mm) with washers for installation.
Be careful not to lose any of these parts.
Note ;
® The unit is not TAP finished on the right
side although there are screw holes in it.
Please only use screws provided to mount
the unit.
® To tighten the screws, press its head down
straight forward.
Installation Hardware
46
Stem Qty
Screw with washer
(M5 X 8mm)
4
Flat-head small screw
(M5 X 8mm)
8
Power Connector 1
Remote Control 1
Lithium Battery (CR2032) T
_____L