Panasonic CQ-VX999EW - Manual (Page 27)

Switching Metal Tape Piay Mode
® Press 1 (MIL) when playing a metal or chromium dioxide (CrOa)
tape.
® Press 1 (MIL) again to cancel.
Note :
Playing non-metal tapes in MTL mode causes high frequency
imbalance, which affects tone quality.
TPS Operation (Tape Program
Search)
0 Press 4 (TPS) to activate the Tape Program Search mode.
0 From the current selection, decide which program you want to
select. Now, press several times forward (up to 9 programs)
or press several times backward (up to 8) to select the
corresponding program number.
(Fast forward:)
1 -.............. ^9
t_________ f
(Rewind:)
0 .................
t_________4
EX1. To select the current program again
press 4 (TPS), and press
once.
EX2. To select the 1st program backward
of the current selection, press 4
(TPS) once, and press two
times.
EX3. To select the next program, press 4
(TPS) and press once.
EX4. To select the 3rd program forward
of the current selection, press 4
(TPS) once, and press “►W” three
times.
Note:
The TPS mode may not work correctly in the following cases. This, however, does not mean that the
unit is defective.
® There is an interval less than 4 seconds or having a high level of noise or hum between programs.
® There is particularly iow-level passage during the program, (particularly if they are of classical
music.)
Note;
To maintain your cassette player in top condition, avoid using tapes that are longer than 90 minutes
(C-90).
“For Inserting a Cassette Tape”
If you insert into the unit a cassette with a loose tape caused by forcing it into cassette with a finger or the
like, the cassette may not be properly reproduced. In such a case, eject the cassette, make the tape tight,
then insert it back into the deck.
CQ-VX999EW
27