Panasonic PT-AE1000 User Manual
Panasonic, Homi, Pt-ae1000e
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
Table of contents
Document Outline
- I
- IMPORTANT: THE MOULDED PLUG (U.K. only)
- Replacement of the lamp is better to be carried out by a qualified technician.
- When replacing the lamp, allow it to cool for at least one hour before handling it.
- Before replacing the lamp, be sure to disconnect the mains plug from the mains socket.
- Do not allow infants or pets to touch the remote control unit.
- In order to get the best picture quality
- Do not touch the surfaces of the lens with your bare
- Screen
- Lamp
- Liquid crystal panel
- Front, back and top view
- Top and front view
- Back and bottom view
- I Calculation methods for screen dimensions
- Setting on a desk/floor and projecting from front
- Mounting in the ceiling and projecting from front
- Setting on a desk/floor and projecting from rear
- Mounting in the ceiling and projecting from rear
- Setting up
- ■ Adjusting the Lens shift dial • Horizontal
- I Projector location range
- Switching the pr
- IMPORTANT: THE MOULDED PLUG (U.K. only)
- I
- I
- NOTE:
- # Facing to the projector
- % Facing to the screen
- COMPONENT IN
- PC IN
- HDMI2 IN
- SCART IN
- HDMI1 IN
- S-VIDEO IN
- VIDEO IN
- 4:3
- 16:9
- 14:9
- ZOOMI
- 4:3
- 16:9
- 4:3
- 16:9
- Adjusting the waveform
- Remote control operation
- Create a new profile
- Menu Navigation
- Displaying the Main menu
- ■ Operating procedure
- 0 LENS CONTROL
- Menu Navigation
- I
- (# LANGUAGE
- Lighter
- Darker
- More greenish
- More
- reddish
- Less bluish
- Move
- left
- Move
- right
- Move
- down
- Move
- H Aspect ratio options and projection example
- POSITION Menu
- Aspect ratio depend on signals
- Shrink
- Enlarge
- LAMP indicator TEMP indicator
- TEMP indicator
- I Cleaning the outer surface of the projector
- I Cleaning the lens surface
- I Cleaning the Air filter
- Replacing the Air filter
- Opening the top cover
- I Removing and replacing the lamp unit
- H Attaching the top cover
- ■ Resetting the LAMP RUNTIME
- Technical Information
- ■ Connection
- Pin assignments and signal names
- Communication settings
- I