Campbell Hausfeld PS120B - Manual (Page 14)

14
Airless Paint Sprayers
Operating Instructions and Assembly Instructions
www.chpower.com
Storage
ShOrT TErm
(lESS ThAN ONE wEEk)
wEAr All NECESSAry
SAFETy GEAr
NECESSAry TOOlS / mATErIAlS:
• Pump Protector Solution
• Plastic Wrap
• 3/4 in. or Adjustable Wrench
OIL OR ALKYD BASED PAINT
If sprayer cleaned with mineral spirits,
simply wrap suction filter housing
in plastic to keep debris out of
suction filter. No other preparation is
necessary.
WATER-BASED PAINT
1. Prepare Pump Protector solution in
bucket as directed on container.
2. Place suction assembly into
solution.
3. Place end of bypass tube into waste
bucket.
4. With prime/spray control in PRIME
position, turn pressure to HIGH
(completely clockwise).
5. Turn power switch ON. Circulate
Pump Protector through bypass
tube until bucket of solution is
EMPTY.
6. Turn pressure to LOW (completely
counterclockwise).
7. Wrap suction filter housing in
plastic to keep debris out of suction
filter.
lONG TErm
(mOrE ThAN ONE wEEk)
8. Remove high pressure hose and
drain. Reassemble high pressure
hose to pump.
9. With spray tip attached to spray
gun, wrap tip with plastic to
protect tip.
water based Paint
Pump
Protector
Prepare Pump
Protector Solution
1
Turn Pressure to LOW
(completely counterclockwise)
P LASTIC WRAP
Wrap Suction Filter
Housing in Plastic
Place Suction Assembly in
Solution
PUmP
PrOTECTION
SOlUTION
wASTE
bUCkET
6
7
Place End of Bypass Tube
into Waste Bucket
With Prime/Spray
Control in PRIME
Position, Turn
Pressure to HIGH
(completely clockwise)
14
2
PUmP
PrOTECTION
SOlUTION
wASTE
bUCkET
PUmP
PrOTECTION
SOlUTION
wASTE
bUCkET
4
3