Using the graphic equalizer – Yamaha MT120S User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
USING THE GRAPHIC EQUALIZER
The MT120S has a stereo 5-band graphic equalizer built in. As the block diagram below makes clear, signals assigned to
the left and right channels by the PAN control and level adjusted using the MASTER fader are sent to the equalizer.
Therefore, It can be used during ping-pong recording, mixdown operation and when recording with the REC SELECT control
set to “L” or “R.” The equalizer cannot be used when the REC SELECT control is set to “1”
—
“4,” however, since each
channel signal is recorded directly on the appropriate track.
The graphic equalizer affects only the signal paths marked with bold lines in the diagram below.
(MONO)
AUX
RETURN
17
AUX
RETURN
MIC/UNE
INPUT
SELECT
r 4 <
INPUT
FADER
PAN
TRACK
1,3
TRACK
2,4
/
■ 0-:
REC
SELECT
MASTER
FADER
GRAPHIC
EQUALIZER
GRAPHIC
EQUALIZER
AUX SEND
MONITOR
MONITOR
1 ,3
SELECT
REC
SELECT
MONITOR
MONITOR
2,4
SELECT
MONITOR /
PHONES
MONITOR/
PHONES
STEREO OUT
AUXSEND
TAPE OUT
MONITOR OUT
-o—
I
PHONES
I
MONITOR OUT
20
M T 1 2 0 S M U L T I T R A C K C A S S E T T E R E C O R D E R