Remote control amp id, Remote control tuner id – Yamaha RX-V663 User Manual
Page 111
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advanced setup
See page 106 for the operation of the advanced setup.
■ Remote control AMP ID
REMOTE
h
MP
Use this feature to set the AMP ID of this unit for remote
control recognition. This feature is useful when you
operate this unit and the other Yamaha receivers/
amplifiers in the same room separately.
Choices:
ID1,
ID2
•
Select “IDl” when the remote control AMP ID code is
set to “5019”.
•
Select “ID2” when the remote control AMP ID code is
set to “5020”.
Setting remote control AMP ID codes
You need to set the remote control AMP ID code for the
remote control.
1
While pressing and holding (DAMP on the
remote control, press (D AV POWER for
more than 3 seconds.
(DAMP
flashes twice.
1
AMP
1
POWER
While holding
Press for 3
down
♦
C
a
SF]
seconds
:o;
flashes
Press the numeric buttons (®) to enter the
code number “5019” or “5020”.
When the setting succeeds, ®
AMP
flashes twice;
however, when it does not,
(DAMP
flashes
repeatedly.
AM»ID
, RttmitE
T
. ooiMMAMPl
«•2
'1
5019
To operate this unit using
IDl
(initial setting)
the default code.
(initial setting)
5020
To operate this unit using
an alternative code.
ID2
The remote control setting
*2 The setting of this unit
■ Remote control TUNER ID
REMOTE TU
Use this feature to set the TUNER ID of this unit for
remote control recognition.
Choices:
ID1,
ID2
•
Select “ID 1 ” when the remote control TUNER ID code
is set to “5007”.
•
Select “ID2” when the remote control TUNER ID code
is set to “5016”.
Setting remote control TUNER ID codes
You need to set the remote control TUNER ID library
code for the remote control.
1
While pressing and holding ® TUNER on the
remote control, press (DAV POWER for
more than 3 seconds.
©AMP
flashes twice.
TUNER
While holding
down
♦
POWER
Press for 3
seconds
I AMP I
flashes
Press the numeric buttons (®) to enter the
code number “5007” or “5016”.
When the setting succeeds,
©AMP
flashes twice;
however, when it does not,
©AMP
flashes
repeatedly.
TUNERID
eod«*1
■', "1
TIMER
5007
To Operate this unit using
IDl
(initial setting)
the default code.
(initial setting)
5016
To operate this unit using
an alternative code.
ID2
The remote control setting
*2 The setting of this unit
i07 En