Remedy, W-l:0ut of phase, W-2 uer 24ri csoft) – Yamaha RX-V663 User Manual
Page 122: I.j-3:leuel error, I.j-4: check prns
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Troubleshooting
1
After AUTO SETUP
Wttntirifi iiteisfios
Cause
Remedy
$«» 1
P9S»
1
W-l:0UT OF PHASE
Speaker polarity is not correct. This message
may appear depending on the speakers even
when the speakers are connected correctly.
Check the speaker connections for proper
polarity (+ or -).
14
W-2-.0UER 24ri CSOft)
The distance between the speaker and the
listening position is over 24 m (80 ft).
Bring the speaker closer to the listening
position.
—
I.J-3:LEUEL ERROR
The difference of volume level among
speakers is excessive.
Readjust the speaker installation so that all
speakers are set in locations with similar
conditions.
Check the speaker connections.
14
Use speakers of similar quality.
—
When “SWFR: TOO LOUD”or “SWFR:
TOO LOW” appears in the result screen, the
output volume of the subwoofer.
32
I.J-4: CHECK PRNS
“EXTRA SP ASSIGN” is set to
Check the presence speaker connections.
14
“PRESENCE”, though the presence channel
signals are not detected.
Set “EXTRA SP ASSIGN” to a setting other
than “PRESENCE”.
33
If the “ERROR” or “WARNING” screens appears, check the cause of the problem, then run “AUTO SETUP” again.
If a warning message “W-1”, “W-2” or “W-3” appears, corrections are made, but they may not be optimal.
If an error message “E-10” occurs repeatedly, contact a qualified Yamaha service center.
118
e
/7