Yamaha RX-V663 - Manual (Page 68)

SIRIUS Satellite Radio™ tuning
Before performing the following operations, press @)SIRIUS
on the remote control.
Ali Channel Search mode
Category Search mode
1 Press ©SEARCH MODE (or ®SRCH
MODE) repeatedly to select “ALL CH
SEARCH”.
2 Press ©PRESET/TUNING/CH <] /1> (or
® PRESET/CH
A
/
V)
repeatedly to search
for a channel within all channels.
• You can search for a channel quickly by pressing and holding
©PRESETH-UNING/CH < /
1>
(or ©PRESET/CH A /
V)
• You can skip channels to the previous or next category by
pressing ©CATEGORY (or © A-E/CAT. <l / O).
Press ©SEARCH MODE (or @SRCH
MODE) repeatedly to select “CAT SEARCH”.
Press ©CATEGORY (or ©A-E/CAT. <l / O)
repeatedly to change the channel category.
Press ©PRESET/TUNING/CH < / > (or
©PRESET/CH A / V) repeatedly to search
for a channel within the selected channel
category.
■ Preset Search mode
Prior to selecting a preset channel in the Preset Search
mode, you must preset SIRIUS channels. For details, see
“Setting the SIRIUS Satellite Radio’*'^ preset channels” on
page 65.
1 Press ©SEARCH MODE (or @SRCH
MODE) repeatedly to select “PRESET
SEARCH”.
2 Press ©CATEGORY (or ©A-E/CAT. d /1>)
repeatedly to change the preset channel
group (A to E).
3 Press ©PRESET/TUNING/CH < / > (or
©PRESET/CH
A / V)
repeatedly to change
the preset channel number (1 to 8).
You can also select the preset channel number directly by
pressing the numeric buttons (1 to 8) (®).
Direct number access mode
Press @SRCH MODE on the remote control
repeatedly to select “ALL CH SEARCH” or
“CAT SEARCH”.
Press the numeric buttons (®) to enter the
desired three-digit channel number.
For example, to enter the number 123, press the
numeric buttons (®) as shown below.
You can search for a channel quickly by pressing and holding
©PRESET/TUNING/CH d/O on the front panel (or
©PRESET/CH A/V on the remote control).
Notó
This unit skips the channels when this unit is All Channel Search
mode or Category Search mode in the following cases (it is not
malfunction of this unit):
- the channel is locked (see page 65).
- the channel is out of service.
- you do not subscribe to the channel.
To display the Sirius ID number displayed in the front panel
display, select channel “0”.
' To enter a one-digit or two-digit channel number, press the
numeric buttons (®) on the remote control and then press
®ENT to confirm the input number.
’ Instead of pressing ® ENT to tune into the channel
immediately, you can wait a few seconds until this unit confirms
the entered channel number.
» If no button is pressed within a few seconds after you enter a
one-digit or two-digit number, this unit automatically confirms
the entered channel number.
• If the selected channel is locked, “PIN:________ ” appears in the front
panel display. Enter the four-digit Parental Lock code number
by using the numeric buttons (®) or press ® ENT to cancel
(see page 65).
64
En