Remote control xm id, And canada models only), Remote control sirius id – Yamaha RX-V663 User Manual
Page 112: U.s.a. and canada models only)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advanced setup
See page 106 for the operation of the advanced setup.
■
Remote control XM ID
REMOTE XM
(U.S.A.
and Canada models only)
Use this feature to set the XM ID of this unit for remote
control recognition.
Choices:
IDl,
ID2
• Select “IDl” when the remote control XM ID code is
set to “5009”.
• Select “ID2” when the remote control XM ID code is
set to “5015”.
Setting remote control XM ID codes
You need to set the remote control XM ID code for the
remote control.
1
While pressing and holding (DXM on the
remote control, press
©
AV POWER for
more than 3 seconds.
(DAMP
flashes twice.
POWER
XM
—
While holding
Press for 3
down
)
seconds
I
a
A
p
I
;o;
flashes
■ Remote control SIRIUS ID
REMOTE SR
(U.S.A. and Canada models only)
Use this feature to set the SIRIUS ID of this unit for
remote control recognition.
Choices:
ID1,
ГО2
•
Select “IDl” when the remote control SIRIUS ID code
is set to “5017”.
•
Select “ID2” when the remote control SIRIUS ID code
is set to “5018”.
Setting remote control SIRIUS ID codes
You need to set the remote control SIRIUS ID code for the
remote control.
1
While pressing and holding (g)SIRIUS on the
remote control, press © AV POWER for
more than 3 seconds.
®AMP
flashes twice.
Press the numeric buttons (®) to enter the
code number “5009” or “5015”.
When the setting succeeds, ®
AMP
flashes twice;
however, when it does not,
(DAMP
flashes
repeatedly.
XlllDcocte
PlHfICtlOil
' IlMiMis
Л
ooiitraiXK 1
шттштшкттт^
., , iD*a ■' 1
5009
To operate this unit using
IDl
(initial setting)
the default code.
(initial setting)
5015
To operate this unit using
an alternative code.
ID2
SIRIUS
While holding
down
POWER
Press for 3
seconds
I
AlilP
I
:o:
flashes
Press the numeric buttons (®) to enter the
code number “5017” or “5018”.
When the setting succeeds, ®
AMP
flashes twice;
however, when it does not,
(DAMP
flashes
repeatedly.
SKtlUSM»
code‘1
Functton
_ HsnietS-.-1
■'i
'
.Щ
5017
To Operate this unit using
IDl
(initial setting)
the default code.
(initial setting)
5018
To operate this unit using
an alternative code.
ID2
*1 The remote control setting
*2 The setting of this unit
The remote control setting
*2 The setting of this unit
108
e
/7