Panasonic PVQ-M2508 - Manual (Page 18)

Timer Recording
Your Combination VCR can be set up to do
a recording while you are away or
othenwise occupied. Up to 8 programs can
be placed in memory. You can choose to
record one time, daily, or weekly.
|\^Check list before you begin.
Q All connections are made (see page 5).
Q Your Combination VCR is plugged in.
□ The clock is set.
Q The tape is long enough.
Q The record tab is in place.
Press PROG to display the
SET PROGRAM screen.
• If a program is already in memory,
press AT repeatedly, and then ► to
select an unused program number.
START STOP CH
CATEGORY;N/A
SELECT START DATE
SELECT
SET
END :* ▼ KEY
:► KEY
iPROG KEY
Press and ► to select and set one of the
following as the DATE:
1-31 = One time recording
DAILY = Same time MON - FRI
WEEKLY SUN-SAT = Same time once a week
Example
PROGRAM TIMER Indicator
1
4
5
Today’s
Date
^8—9 ......... 31— 1,-2........
7 SELECTA / T Selection Order DAILY
(^WEEKLY.................WEEKLY____ WEEKLY
_J
(SAT) (MON) (SUN)
3
Press AT and
^
Remaining Items:
to select and set '
each of the remaining * ^
Items at right. outside
source recording
• Category [N/A (not
applicable), SPORTS,
MOVIE, COMEDY,
MUSIC, DRAMA]
To Make Corrections * Speed (SP, LP, SLP)
Repeatedly press ► or -4 to move
the cursor to the right or left, and then make the correction.
Press PROG to end the
program.
• This screen appears for confirmation.
P OT START STOP CH SPD
CANCEL;AOD/DLT KEY
SELECT 1 - 8:A
w KEY
ENTER :► KEY
END :PROG KEY
To Enter More Programs
Press AT and ► to select and set a blank program number,
and then repeat steps 2 and 3.
Press PROG to exit this mode and return to the
normal screen.
• The PROGRAM TIMER indicator lights on the front panel.
• If you’re using a cable box, make sure that it is tuned to the desired
channel and the power is left on for timer recording.
Two minutes before the Timer Recording starts, ‘TIMER REG
WILL START SOON” will appear on-screen.
18