Panasonic PVQ-M2508 - Manual (Page 25)

Unit and Cassette Information
( Erase Protection (Record Tab) ] [ DST. (Daylight Saving Time) J
Cassettes have a record tab to ensure that
recordings are not accidentally erased.
To prevent accidental
erasure, break off the tab
^
4
,^
with a screwdriver.
To record again, cover the
hole with cellophane tape.
Your Combination VCR can be set to automatically
adjust the clock for Daylight Saving Time, (page 9.)
Spring (First Sunday in April)
When set to DST:ON, the Combination VCR will
automatically set the clock ahead one hour.
Autumn (Last Sunday in October)
When set to DST:ON, the Combination VCR will
automatically set the clock back one hour.
• If your area does not observe Daylight Saving Time,
select DST: OFF.
• Keep these time changes in mind when programming the
Combination VCR for timer recordings.
( Maximum Record/Playback Time }
Only use tapes with the mark in this unit.
Tape Speed
Setting
Type of Video Cassette
T60 T120 T160
SP
(Standard Play)
1 Hour 2 Hours
2 Hours
40 minutes
LP
(Long Play)
2 Hours 4 Hours
5 Hours
20 minutes
SLP
(Super Long Play)3 Hours 6 Hours
8 Hours
Reset all Combination VCR Memory FunctionsJ
Use when moving the Combination VCR to a new
location, or if a mistake was made in the One Time
Setup section.
• Make sure a tape is not inserted in the Combination VCR.
1) Press POWER to turn the Combination VCR on.
2) Hold down both the PLAY and REWIND buttons
on the Combination VCR for more than 5
seconds.
• The power will shut off.
3) Turn the power back on and perform the One
Time Setup section on page 8.
Head Cleaning
Your Combination VCR will not normally require
head cleaning, however, the heads may become
clogged when playing an old or damaged tape.
Head Clog Sensor
If head cleaning becomes
necessary, the
Combination VCR will
display the screen shown
to the right during playback
of a video tape. To exit this
screen, press PLAY on the
remote control or
Combination VCR.
■ Use "dry” type head cleaning cassette* * only.
• Be sure to follow the cleaning cassette instructions
carefully. Excessive use of a cleaning cassette can
shorten head life.
D C Product Specifications
VIDEO HEADS MAY
NEED CLEANING
PLEASE INSERT HEAD
CL FAN ING CASSETTE
OR REFER TO MANUAL
END:PLAY KEY
• If using a head cleaning cassette does not solve the
problem, contact your nearest Factory Service Center
or authorized Service Center. (See page 27.)
* Cleaning cassette part No. NV-TCL30PT is
recommended.
Display
Picture Tube:
VCR
Video Recording System: 2 rotary heads helical scanning
25 inch measured diagonal 110“
deflection Picture Tube
Audio Track:
Tuner
Broadcast Channels:
CABLE Channels:
General
Power Source:
Power Consumption:
Television System:
Speaker:
1 track
VHF2-13, UHFU~69
Midband A through I (14-22)
Superband J through W (23-36)
Hyperband AA-EEE (37-64)
Lowband A-5-A-1 (95-99)
Special CABLE channel 5A (01)
Ultraband 65-94,100-125
120V AC, 60 Hz
Approx. 149 watts (Power, On)
Approx. 5 watts (Power Off)
EIA Standard NTSC color
1 piece
Operating Temperature: 41“F-104“F (5*’C-40“C)
Operating Humidity:
Weight:
Dimensions:
10%-75%
73 lbs. (33 Kg)
24-15/16” (W) X 23-1/0” (H) X
18-1/4” (D)
634 (W) X 588 (H) X 464 (D) mm
Note: Designs and specifications are subject to change
without notice.
25