Configuration roadmap, Data preparation, Configuration procedure – Panasonic NN46240-502 User Manual
Page 52: Step 1 configure router a, Step 2 configure router b, Step 3 configure router c
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration - LAN Access and MAN Access
3 Ethernet interface configuration
Figure 3-1 Networking diagram of Ethernet interface configuration
RouterC
Configuration roadmap
The configuration roadmap is as follows:
• Configure a description for each router.
• Configure IP addresses for interfaces on each router.
Data preparation
To configure an Ethernet interface, you need the following data:
• Interface number
• IP address of the interface
Configuration procedure
Step 1 Configure Router A.
<RouterA> system-view
[RouterA] interface gigabitethernet 1/0/0
[RouterA-GigabitEthernet1/0/0] description RouterA
[RouterA-GigabitEthernet1/0/0] ip address 202.38.165.1 255.255.255.0
[RouterA-GigabitEthernet1/0/0] quit
Step 2 Configure Router B.
<RouterB> system-view
[RouterB] interface gigabitethernet 1/0/0
[RouterB-GigabitEthernet1/0/0] description RouterB
[RouterB-GigabitEthernet1/0/0] ip address 202.38.165.2 255.255.255.0
[RouterB-GigabitEthernet1/0/0] quit
Step 3 Configure Router C.
<RouterC> system-view
[RouterC] interface gigabitethernet 1/0/0
[RouterC-GigabitEthernet1/0/0] description RouterC
[RouterC-GigabitEthernet1/0/0] ip address 202.38.165.3 255.255.255.0
[RouterC-GigabitEthernet1/0/0] quit
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
3-9