Panasonic NN46240-502 - Manual (Page 70)

Nortel Secure Router 8000 Series
Configuration - LAN Access and MAN Access 4 VLAN configuration
Figure 4-6 Networking diagram of configuring VLANs to communicate through a router
GE2/0/0.1: 10.110.4.3/24
GE2/0/0.2: 10.110.3.3/24
GE1/0/0.1: 10.110.6.3/24
1GE1/0/0.2: 10.110.5.3/24
9
VLAN30
10.ÏTÔ.4.0724
SwitchA
m VLAN40
10T1073''0/24
9 t|
VLAN10
10.110.6.0/24
SwitchB
10.110.5.0/24
Configuration roadmap
The configuration roadmap is as follows:
• Configure the encapsulation mode on all the Ethernet interfaces to 802.1Q.
• Configure the IDs of the VLANs to which each Ethernet interface belongs.
• Configure the IP address of each Ethernet interface.
Data preparation
To complete the configuration, you need the following data.
• The VLAN IDs of the Ethernet subinterfaces GE 1/0/0.1 and GE 1/0/0.2 are 10 and 20
respectively.
• The VLAN IDs of the Ethernet subinterfaces GE 2/0/0.1 and GE 2/0/0.2 are 30 and 40
respectively.
• The IP addresses of GE 1/0/0.1 and GE 1/0/0.2 are 10.110.6.3 and 10.110.5.3
respectively.
• The IP addresses of GE 1/0/0.1 and GE 1/0/0.2 are 10.110.4.3 and 10.110.3.3
respectively.
Configuration procedure
Step 1 Configure the interface connected with Switch B on the router.
• Create and configure the subinterface GE 1/0/0.1.
<Router> system-view
[Router] interface gigabitethernet 1/0/0.1
[Router-GigabitEthernet1/0/0.1] vlan-type dot1q 10
[Router-GigabitEthernet1/0/0.1] ip address 10.110.6.3 255.255.255.0
[Router-GigabitEthernet1/0/0.1] quit
Issue 5.3 (30 March 2009) Nortel Networks Inc. 4-11