Panasonic SCCH52 - Manual (Page 10)

Listening to Preset Stations (Preset Tuning)
Be sure you’ve completed the steps of “Memory presetting" on
page 9.
This example in the figure shows how to listen to FM preset channel
3;
FM
TUNING MODE
C
TUNING
V A
4 VOLUME
Press FM.
The power will be automatically on.
Press TUNING MODE to
select “PRESET”.
Each time you press the button,
“MANUAL” and “PRESET’ will appear
alternately.
Manual tuning (When stations have not been
preset):
1. Press FM or AM.
2. Press TUNING MODE to select “MANUAL”
Each time you press the button, .“MANUAL” and “PRESET’ will
appear alternately.
3. Press V or A to tune in the desired broadcast.
4. Press VOLUME to adjust the volume as you like.
Press V or A to seiect the
preset channei.
“STEREO" lights when an FM stereo
broadcast is being received. “QUARTZ
LOCK" lights when you precisely tune
in a broadcast station.
STEREO
Preset Channel QUARTZ LOCK
Press VOLUME to adjust the
volume as you like.
D D l C I l T FM MODE/BP
----------^ ^ i ,
O ; ; / t a ; j
Switching the mode from stereo to monaural
while listening to an FM station:
Press FM MODE/BP.
MONO
The sound reception mode switches to “MONO” (monaural)
when the FM MODE/BP button is pressed.
When “MONO” indicator goes off;
Use this setting for normal listening. Both stereo and monaural
sounds can be heard as they are.
When “MONO” indicator lights up:
Use this setting when listening to or our recording in monaural.
Ail sound reception including stereo sound, is in monaural.
For your reference:
if too much noise is produced in the FM stereo mode, press
FM MODE/BP and check “MONO" lights up.
The sound will then be heard in monaural. If the broadcast
signal is weak, or if there is a large amount of interference,
you will get a clearer sound in “MONO" mode.
You cannot memorize the stations in “MONO” mode.
10