Panasonic SCCH52 - Manual (Page 18)

Recording from Radio Broadcasts
• You can use normal and chrome tapes.
• Check that the tape’s tabs (see page 25) are intact.
• The leader tape must be wound up before-hand, (See page 17)
TUNING
V Л
Press V or Л to select the
preset channel.
A EJECT
REVERSE MODE
О
REC PAUSE
C-——
FM
L.
AM
Press ^ EJECT on deck 2,
and then Insert the tape.
Close the holder.
Press REVERSE MODE to
select the reverse mode.
: One side will record, and then
the tape will stop automatically
at the tape end.
: Both sides will record (forward
side “»■ reverse side), and then
the tape will stop automatically
at the tape end.
c;:o ; Same as above. (When you
press REC PAUSE, “ c;::?" will
be automatically switched over
to “ Z 3" . )
Press REC PAUSE to put the
cassette deck Into the re­
cording standby mode.
"fRE^" will light.
J Press or ► to start re­
cording.
►; When recording on either the
forward side or both sides.
When recording only the reverse
side.
To stop recording:
Press □.
To cut an unnecessary part while recording:
1. Press REC PAUSE,
The cassette deck will go into the recording standby state.
2. To resume recording, press or ► corresponding to the direction
in which recording is taking place.
To reduce the noise while AM recording
(Beat proof function)
While in the recording standby mode of AM band;
Press FM MODE/BP.
Each time you press the button, BP 1 and BP 2 will be displayed
alternately.
Select the position where there is less noise.
Press FM or AM to select the
band.
Н П H r 1
->
Й М P p p
t____ ^........ 1
18
TUNING MODE
C ^
Press TUNING MODE to
select “PRESET”.
You can also tune in using “MANUAL"
mode.