Panasonic DVD-CV35 - Manual (Page 39)

DVD
No subtitles. Subtitles appear only with discs which contain them.
Subtitles are cleared from the TV monitor. Display the subtitles. (J) ©
Alternative soundtrack (or
subtitle) languages fail to be
selected. An alternative language is not selected with discs which do not contain more than one language.
In the case of some discs, the alternative language cannot be selected by operating the [AUDIO] or
[SUBTITLE]. Try selecting it from the disc’s menu if one is available. ©
Angle cannot be changed. This function is dependent on software availability. Even if a disc has a number of angles recorded,
these angles may be recorded for specific scenes only (when “ ” lights up on the unit’s FL
display).
Soundtrack and/or subtitle
language is not the one selected
at the initial settings.
If the soundtrack and/or subtitle language does not exist on the disc, the language selected at the
initial settings will not be seen/heard.
The disc’s menu is displayed in
French (example).
The setup “3 Menus” of “1 Disc Languages” is set to French: Select English. ©
Sound does not come from a
speaker.
Check the connections. 0 ©-©
If you have connected this unit to an amplifier (with built-in decoder) through the digital audio output
terminal, go to the initial settings menu “7 Digital Audio Output" and change the settings to
“Bitstream" for “2 Dolby Digital" or “3 DTS Digital Surround". ©
You have forgotten your ratings
password.
Reset all the settings to Factory
Preset. While stopped, press and hold [ ] and [11] on the unit and then also press and hold
[^ OPEN/CLOSEJ on the unit until “Initialized" disappears from the television (after approx.
3 seconds).
All initial settings will return to the default values.
The vocals cannot be turned off. You have selected an audio channel that includes a vocal channel. Read the disc’s jacket to choose
the correct channel. 0
There are no vocals while playing
Karaoke DVD.
When you have connected this unit to other equipment through the DIGITAL AUDIO OUT terminal,
go to “7 Digital Audio Output” in the initial settings and change the setting for “2 Dolby Digital" to
"PCM". © © © 0
A menu is shown after playing
each song on a Karaoke DVD. Most Karaoke DVDs are designed to do this. Some discs have an item in the menu that allows you
to play all the songs. 0
Video CD
No menu play. This function works only for Video CDs with playback control. Q
Self-diagnosis display function
When an error or trouble is detected during operation, a message appears in the FL display.
When a message has appeared, check the details given below.
Message Unit status Remedy
CHECK THE DISC Disc is dirty. Wipe the disc clean. ©
HDD
□ □ stands
for a number.
Trouble is likely to have occurred. The
number following “H" depends on the status
of the unit.
Press [POWER c!)/l) to switch the unit to the standby mode and
then back to ON. Alternatively, press [POWER cb/l] to switch the
unit to the standby mode, disconnect the AC power supply cord,
and then reconnect it.
0)
o
c
2
oc
3
2
V.
£
• If the message fails to be cleared, even when remedial action is taken, ask a service technician to repair the unit.
RQT5508