Panasonic kx-fmc230 - Manual (Page 103)

Operations
Multi-Function Center (cont.)
PROBLEM CAUSE & REMEDY
The facsimile unit cannot print
the documents received on your
PC.
•Another device is in use. Check the outbox, then wait until the other
device is finished or cancel it.
•The com port was set improperly. Check the properties and set the
com port with ‘Tesf again.
•The com port is competing with the mouse or network card, or uses
the same IRQ as MFC-Print. Change the IRQ setting (refer to your
Windows user manual).
•The performance of your PC is not sufficient. At least, CPU386 (DX
33MHz) and 4M RAM are necessary.
•An OS (Macintosh, DOS, Win NT, etc.) which the Multi-Function
Center does not support was used. Use Windows 95 or
Windows 3.1/3.11.
•All com ports are in use. Assign a com port for the Multi-Function
Center.
Documents are received by the
facsimile unit but I want to
receive them on the PC.
•The Inbox was set to pause. Remove the check mark from the Pause
Inbox in the Message Center window.
•The PC link feature (#14) of the facsimile unit is set to OFF. Set to
ON (see page 92).
•The Message Center is not running. Open it.
Documents are received on the
PC but I want to receive them on
the facsimile unit.
•The Inbox was not set to pause. Set the Inbox to pause or close the
Message Center.
•The Message Center is running. Remove the check mark on the
Load in Message Center with Windows property.
I want to print a received fax with
the pre-selected printer.
•Select Automatically Print Incoming Faxes in the Receive dialog
box of the Inbox properties.
I want a received fax to be printed
by another printer. •Set the desired printer as default in the Print Settings box, or select
the desired printer in the Print dialog box.
Documents cannot be scanned
on the PC.
•See the Viewer instructions in the operating instructions or help list.
•There is not enough hard disk capacity. Delete unnecessary
applications or data.
•The MFC scan program was activated when other applications were
running and the swap file was full. Check the swap file size and
extend the swap file.
•The MFC scan program was activated and there is not enough RAM
capacity. Close the applications in progress.
•Try cold reboot.
Documents cannot be sent by the
PC. •The receiving unit is busy. Check the outbox and error status log.
•The MFC is installed incorrectly. Install it again.
•There is not enough RAM capacity. Try again after closing other
applications.
•A different fax software was used instead of the Multi-Function
Center. ,
For Assistance, Call 1 -800-435-7329
103