Starting to use, Turning on the power – Panasonic DIGITAL MULTIMEDIA PROJECTOR PT-L501XU User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Starting to use
Turning on the power
®Remove the lens cover.
(D
Connect the accessory power cord to a 100 V-240 V AC (50 Hz/60 Hz)
power supply.
(3) Press the MAIN POWER switch to the “|” side to turn on the power.
The POWER button on the projector will illuminate red. You can check
whether a signal is being input or not by checking the status of the RGB
INPUT indicator. Refer to page 24,
(4) Press the POWER button on the projector or remote control unit.
The POWER button on the projector will flash green. After a short period,
the button will illuminate green, and a picture will be projected.
(5)
Turn the focus ring to make broad adjustments to the picture focus.
©Set the projection method, (pages 20 and 37}
©Press the input select (INPUT, RGB, VIDEO) buttons on the projector
or remote control unit to select the input signal.
The input signal selected will change as shown in the table below each
time an input select button is pressed.
RGBI(YP
b
P
r
I)
—>
RGB2(YP
b
P
r
2)
Projector
INPUT
T
S-VIDEO
Í^
VIDEO
Remote control
RGB
RGBI(YP
b
P
r
I)
RGB2(YP
b
P
r
2)
unit
VIDEO
S-VIDEO
VIDEO
©Press the VOLUME +/- buttons on the remote control unit to adjust
the volume.
Refer to page 25 for details on how to adjust the volume using the buttons
on the projector control panel.
22