Adjusting the position, Horizontal position, Vertical position – Panasonic DIGITAL MULTIMEDIA PROJECTOR PT-L501XU User Manual
Page 33: Video size, Dot clock, Clock phase, Note, Vertical position video size
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Adjusting the position
Use the A and ▼ buttons on the
projector or remote control unit to
select an item, then press the
ENTER button or the ◄ or ►
buttons to display the adjustment
screen, and then use the ◄ or ►
buttons to make the adjustment.
When an RGB/YP
b
P
r
signal is
being input
P O S I T I O N
t
S E L C T tWtIM E N T E R
E S C
When an S-VIDEO/VIDEO signal is
being input
^ Z.
1=
t
S E L C T EH7EiqE N T E R HENH ESC
HORIZONTAL POSITION
Press the ◄ button to move the
picture to the left, and press the ►
button to move the picture to the
right.
VERTICAL POSITION
Press the ◄ button to move the
picture down, and press the ►
button to move the picture up.
VIDEO SIZE
(S-VIDEOA/IDEO only)
Press the ◄ button to make the
picture smaller, and press the ►
button to make the picture larger.
DOT CLOCK
(RGB only)
Periodic striped pattern interference
(noise) may occur when a striped
pattern such as the one below is
projected. If this happens, use the
◄ and ► buttons to adjust so that
any such noise is minimised.
CLOCK PHASE
(RGB only)
Adjust the DOT CLOCK setting first
before carrying out this adjustment.
Use the ◄ and ► buttons to adjust
so that the noise level is least
noticeable.
NOTE:
• When an UXGA signal is being
projected, interference may not
be completely eliminated when
the DOT CLOCK and CLOCK
PHASE adjustments are carried
out.
c
(D
1-
d>
a
O
o
CO
CQ
33