360 Systems Instant Replay DR-554 - Manual (Page 13)

Instant Replay Owner's Manual Page 13
DISPLAY MODULE
THE DISPLAY MODULE
For most operations, the display shows the Index number, Cut Name, and the running time of the
currently selected Cut.
The currently selected Bank number is displayed in the lower right corner, followed by the Hot-Key
Assignment of the current Cut. If the displayed Cut is not assigned to a Hot-Key in the current Bank,
this number will be 00.
When a Cut starts playing, the lower line of the Display changes to show the Name of that Cut,
followed by the running time in Hours:Minutes:Seconds, as shown in the picture above.
Other messages appear on the display during special operations. These are explained in appropriate
sections of this manual.
HOT-KEYS
There are four primary uses for Hot-Keys:
§ Triggering playback of assigned Cuts
§ As an alphanumeric keyboard
§ Bank selection, using the top row of keys
§
Drive selection, when an external drive is connected, using the “E” and “I” keys
The main array of 50 buttons are Hot-Keys numbered 1 through 50. A Hot-Key's primary function is
to trigger playback of a Cut assigned to it. Hot-Keys light up whenever their assigned Cut is playing.
Most buttons additionally carry an alphabet character. In operations that require the entry of text and
numbers, such as Change Cut Name, Change Bank Name and Move Cut, the Hot-Keys serve as a
typewriter-style keyboard. Key number 50 is a Backspace key that allows deleting characters. Keys
48 and 49 are cursor movement keys that allow you to move to any character position. Key number
40 is an A
STERISK (*) character used by the Find function. Keys 41 to 47 all function as a space bar.
In the Bank Select mode, the numbers 1 through 10 on the top row select the corresponding Banks
numbered 1 through 10. When an external drive is connected and enabled in the Configuration menu,
the I and E keys select the Internal or External drive.