Aviom A-16 - Manual (Page 32)

Aviom A-16 Personal Monitor Mixing System
24
Audio Outputs
The audio outputs on the rear of the A-16 Personal Mixer can be used with head-
phones, in-ear monitors, powered speakers, or any other device that can accept a line
level audio output. Stereo, dual-mono, and mono outputs are available by using the
appropriate cables
Stereo
The TRS outputs on the Personal Mixer are stereo. Any pair of stereo headphones can
simply be plugged into the jack.
To connect a set of stereo speakers (studio monitors or stage speakers), use a stereo to
dual-mono adapter to split the stereo signal into separate left and right mono signals.
Then connect a standard mono cable to the audio input of the left and the right ampli-
fier for the speakers.
Mono
To use a mono amplifier, powered speaker, etc., connect a standard audio interconnect
cable (tip and sleeve “guitar cord” type) from the audio output on the Personal Mixer
to the audio input on your mono device.
To use a mono input on a device that has an XLR input connection, you need to use a
cable that has a tip-sleeve 1⁄4” jack on one end and an XLR on the other. Using a tip-
ring-sleeve 1⁄4” jack to XLR cable will cause the left and right channels to be summed,
resulting in a loss of level.
To make a custom adapter cable using a TS Jack
Connect the Tip signal to XLR Pin 2. Connect the Sleeve signal to XLR Pin 1.
Connect the unused XLR Pin 3 to XLR Pin 1.
To make a custom adapter cable using a TRS Jack
Connect the Tip signal to XLR Pin 2. Connect the Ring signal to XLR Pin 3.
Connect the Sleeve signal to XLR Pin 1.
1 2
3
1 2
3