Aviom A-16 - Manual (Page 58)

Aviom A-16 Personal Monitor Mixing System
50
cable connected to the first Personal Mixer should be connected to the A-
Net In jack. The next device is connected from the Out on the first device
to the In on the next.
Problem: A Preset was saved with a stereo link active but when the Preset is
recalled the channels are mono. (Or, a Preset was saved with mono channels, but on
recall the Channels are linked.)
Possible Solutions:
• The status of the stereo link is set by the front panel Link switches on
the A-16T Transmitter. If a Preset is recalled and the position of the
Link switch is different from when the Preset was saved, the Preset will
be adjusted to agree with the current hardware settings on the A-16T
Transmitter front panel. If this happens, simply change the position of the
Link switch on the A-16T. Your current mix will be updated immediately.
Problem: A Channel was assigned to one Group and now it is suddenly part of a
different Group.
Possible Solutions:
• When you link a stereo Channel pair with the Link switch on the A-16T
after a Group has been created, it is possible that channel characteristics
could change. This includes the volume, pan, mute status, and Group
assignment. The rule to remember is that the even-numbered channel (the
right side of the pair) will inherit the characteristics of the odd-numbered
channel (left side of the pair).
Problem: When editing a Group that contains a large number of Channels, it
seems like all of the LEDs are pulsing.
Possible Solutions
• This is a normal effect of the current-limiting circuit and is not an indica-
tion of a problem.
Problem: I don’t think my Preset was saved.
Possible Solutions:
• When saving a Preset, make sure that the R
ECALL
and G
ROUP
buttons are
both held down before pressing a memory location button. The Preset is
saved when you release your finger from the memory location button.
When a Preset has been saved correctly, you will see all sixteen Channel
LEDs flash momentarily to confirm the save operation.
Problem: In Group mode, I can’t select a new Channel.
Possible Solutions:
• If you already have three Groups defined and attempt to select a new
Channel that is not part of an existing Group, the button press is ignored.
This happens you are trying to create a new which would exceed the limit
of three Groups per Preset. Edit or delete an existing Group to continue.