Aviom A-16 - Manual (Page 41)

Aviom A-16 Personal Monitor Mixing System
32 33
other.
Using a TRS insert, the effects device would have the Send cable plugged into its Input
and the Return cable plugged into its Output. This wiring completes the loop without
interrupting the audio being played though the console.
Console TRS
Channel Insert
Effect Output
Effect Input
Signal flows from the console into the effect device and back into the console
To use the A-16T Transmitter with this insert layout, both the In and Thru jacks on the
Transmitter are used. The main console’s Insert Send should be plugged into the In
jack on the Transmitter. The Thru jack on the Transmitter is used to return the signal
to the console, completing the audio loop. In this case the A-16T acts like an effects
device, but it has no audible effect and does not change the audio signal in any way.
Console TRS
Channel Insert
A-16T Thru
A-16T In
Signal flows from the console into the A-16T and back into the console
Note: There is some variation in the send/return insert wiring on consoles. Some
manufacturers use the TRS tip connection for a send function, while others use the
ring connection. Consult your console’s documentation.
Discreet Insert Send and Return Jacks
If a console uses separate jacks for Send and Return functions, the cable connections
are much more obvious. The Send from the Insert point on the console is connected to
the A-16T Transmitter In jack. The Thru on the A-16T is connected to the Return jack
on the console to complete the loop.
Insert Return
Insert Send
A-16T Thru
A-16T In
Separate cables connect signals into the A-16T and back into the console