Aviom AN-16/i-M - Manual (Page 27)

19 AN-16/
i
-M M
ic
i
Nput
M
odule
u
ser
G
uide
Channel Thru Jacks
The sixteen XLR balanced audio Thru jacks on the AN‑16/i‑M provide an exact
copy of the mic signal plugged into the Input jack just above it. This provides
a passive splitter that can send a copy of the audio inputs to an analog audio
mixer used for monitors in a digital snake installation, for example.
No front‑panel adjustments are passed on to the Thru connector with the
exception of the phantom power used by condenser mics.
Channel Inserts
Each of the sixteen audio channels has a dedicated set of insert send/return
jacks. The insert jacks are ¼‑inch balanced TRS and are designed to allow
audio processors such as compressor/limiters to be added to each channel.
Connect a cable from the channel’s S
eNd
jack to the audio input of the effects
processor. Connect another ¼‑inch cable from the device’s output to the
R
etuRN
jack on the AN‑16/i‑M channel to be processed.
CAUTION
Risk of electric shock!
Do Not Open
AVIS: Risque de choc electrique!
Ne pas ouvrir
WARNING!
To reduce the risk of fire or
electric shock do not expose
this product to rain or moisture .
CAUTION: Replace
fuse with same type
fuse and rating.
250VAC~ F4AL
100-240VAC~
50/60 Hz
60W
Send Send Send
Return Return Return
16 15 14
16 15 14 13 12
16 15 14 13 12
(DC Coupled Passive Splitter)
Mic/Line
Input
Thru
XLR Pin 2 Hot
The Insert Send jack can be used as a direct line output.
Direct Line Outputs
The AN‑16/i‑M Input Module can also be used as a stand‑alone mic preamp.
The insert send/return functions as a line output if only the Send jack is
used.
To send a channel’s audio signal to another line‑level device, connect a cable
(TS or TRS) from the channel’s S
eNd
jack to the input of the device. Do not
connect a cable to the AN‑16/i‑M R
etuRN
jack as this will break the line out
connection, creating an insert send/return path, as described above.