Aviom AN-16/i-M - Manual (Page 37)

29 AN-16/
i
-M M
ic
i
Nput
M
odule
u
ser
G
uide
32-Channel Snake
The 32 x 0 configuration has all audio inputs on one side of the system and
all audio outputs on the other side. This setup could be used to send 32 mic
signals form a stage to a front‑of‑house (FOH) mixing console, for example.
AN-16/o AN-16/i-M
16 Channels In 16 Channels Out
AN-16/o AN-16/i-M
16 Channels In 16 Channels Out
A-Net
A-Net Expansion
Audio channels 17-32
Audio channels 1-16
32 channels are sent from a stage to the FOH mix position.
With this configuration, two Pro16 input modules receive thirty‑two analog
audio (mic‑ or line‑level) signals as inputs. One input module contains
channels 1‑16, while the other has channels 17‑32.
To configure a 32 x 0 system:
Connect the first sixteen mic or line‑level audio sources to 1.
inputs 1‑16 on the first Pro16 input module.
Connect the second group of sixteen audio sources to
2.
inputs 1‑16 on the second input module.
Connect a Cat‑5e cable from the
3. A‑Net Out jack on the first
input module to the A‑Net Expansion jack on the second
input module.
Connect a cable from the A‑Net Out jack on the second
4.
Pro16 input module and run it to the destination where the
AN‑16/o Output Modules are located, and plug it into the
A‑Net In jack on the first AN‑16/o Output Module.
Connect a Cat‑5e cable from the
5. A‑Net Expansion jack on
the first AN‑16/o to the A‑Net In on the second AN‑16/o.
Patch the audio outputs from the two AN‑16/o Output
6.
Modules into the desired destinations.
Either AN‑16/i or AN‑16/i‑M Input Modules can be used as needed for this
application.
Remember that the maximum cable length between A‑Net devices is 500
feet (150 meters). Always use Cat‑5e UTP cable.