BUCHI SpeedDigester K-436 - Manual (Page 31)

6 Operation
31 K-425 / K-436 Operation Manual, Version A
*CL
ICK
*
5
6
To Scrubber or
water jet pump
Example with two glass
caps installed!
Check for proper and • tight seating of each rubber sealing 5.
➥ If necessary unlock the handles again and readjust the suction module!
Plug the suction hose with plug onto the suction module
• 6.
➥ The plug catches with a noticable *click* sound.
If applicable, follow the previous steps to install a suction module on a second rack.
•
Switch on the Scrubber or water jet pump and activate the fume hood ventilation. •
➡The rack(s) can now safely be processed in the SpeedDigester.
Note
Clean all glass parts before mounting to avoid cross contamination. •
When a water jet pump is used, hazardous vapours can escape into the environmental air if the •
suction is inadequate.
If a Scrubber without condensation step is used, the condensate that accrues must be absorbed
•
by means of a Woulff bottle between the SpeedDigester K-425 / K-436 and the Scrubber.
When operating with 3rd party sample tubes no insulation caps and glass caps are available. In
•
this case, all positions must be equipped with samples!