Compex ONE - Manual (Page 20)

17
EN
One - U
ser M
anual
Battery insertion
Open the cover of the battery compartment and insert the battery with the label
upwards so that the + and - poles of the battery are facing the contacts of the device.
Then put the cover back in place. If the device is not to be used for more than 3
months, ensure the battery is fully charged. If the device is not to be used for more than
6 months, ensure the battery is fully charged and remove it from the stimulator. Before
removing the battery, switch off the stimulator.
Connections
Connecting the charger
The One stimulator has considerable operating autonomy, as it uses a battery. To
recharge it, connect the charger supplied with your device to the base of the device,
then plug the charger into a socket. Remove any stimulation cables connected to the
stimulator before recharging it. We strongly recommend you to fully charge the battery
before using it for the first time as this will improve its performance and life span.
Connecting the cables
The stimulator cables plug into the 4 sockets on the front of the device. Cables can be
connected simultaneously to the four channels of the device. Both the sockets and
the cables are colour-coded to simplify use and facilitate identification of the different
channels:
Blue = channel 1
Green = channel 2
Yellow = channel 3
Red = channel 4
+
-
ONE