Cub Cadet SLTX1000 Series User Manual
3urihvvlrqdo6krs0dqxdo
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Chapter 1: Introduction
- Chapter 2: Engine related parts
- Chapter 3A: Steering
- Chapter 3B: Electronic Power Steering
- Chapter 4: Body panels
- Chapter 5: Hydro. Drive and brake system
- About this chapter
- Externally repairable drive system problems
- Indications that a transaxle is not warrantable
- Brake adjustment
- Neutral control adjustment
- Linkage: pedal shaft
- Pedal shaft assembly removal
- Belt control; tensioner and idler pulleys
- Drive belt replacement
- Changing transaxle hydraulic fluid
- Brakes
- Transaxle removal and replacement
- Chapter 6: CVT Drive and brake system
- About this chapter
- About the variable speed drive system.
- Externally repairable drive system problems:
- Indications that a transaxle is not warrantable
- Brake adjustment
- Gear selector
- Tensioner pulley control rod
- Linkage: pedal shaft
- Pedal shaft assembly removal:
- Linkage: pedal tie strap
- Belt control: tension make-up pulley
- Belt control: variable speed pulley
- Belt control: tensioner pulleys
- Drive belt replacement
- Transaxle removal and replacement
- Transaxle repair
- Chapter 7: electrical system
- Introduction
- RMC Module
- Key switch
- RMC Module
- RMC module plug test (electric PTO)
- RMC module plug test (manual PTO)
- Electric PTO switch
- PTO relay
- PTO switch (manual PTO)
- Brake switch (manual PTO)
- Brake switch (electric PTO)
- Park brake switch
- Reverse Safety Switch
- Seat Safety Switch
- Starter solenoid
- Start Circuit
- Run Circuit
- Run Circuit / Reverse Caution mode
- Engine shutdown circuits
- Charging circuit
- PTO Circuit (electric PTO)
- Reverse Mower Control (RMC) circuit operation
- Electrical diagnosis
- Electronics
- Electrical environment: AC Vs. DC
- Ohm’s Law
- Kirchhoff’s current law
- Kirchhoff’s voltage law
- How the system is wired together
- Types of circuits
- Series
- Parallel
- Series/parallel
- Shorts
- Opens
- Increased resistance
- The Tools
- Digital multimeter
- Wiring diagram or schematic
- Fused jumper wires
- Test lights
- Self-powered continuity lights
- Ammeters and specialized charging system testers
- Batteries
- Charging the battery
- Checking battery condition
- Battery Testers
- Adjustable load testers
- Fixed load testers
- Conductance testers
- Battery discharge test
- Storage of batteries
- Electrical Troubleshooting
- Voltage Drop Test
- Testing switches
- Diodes
- Relay
- Schematics
- Chapter 8: Cutting Decks and lift shaft
- Cutting decks
- Deck removal
- Cleaning the deck
- To clean the deck while it is removed:
- Blades
- Spindles
- PTO belt
- Timing belt
- Leveling the deck
- Side to Side Leveling
- Front To Rear Leveling
- Deck Wheel Adjustment
- Deck lift shaft assembly bushings
- Deck lift shaft assembly removal/replacement
- Deck lift links and cables
- Chapter 9: Maintenance intervals
- Hydro-gear Appendix