Hydrostatic removal, Series 5000 – Cub Cadet 5000 Series User Manual
Page 11
Series 5000
7
2.34. Remove the PTO clutch from the PTO input
shaft.
3.
HYDROSTATIC REMOVAL
NOTE: The series 5000 uses a BDU 21L
Hydrogear pump to power the transmission.
3.1.
Remove the fender, floor and ROPS.
3.2.
Remove the four screws securing the front seat
mounting bracket to the frame using a 1/2”
socket.
Figure 2.34
Clutch
Figure 3.2
Seat Mounting
Bracket
Screws
3.3.
Remove the two screws and washers securing
the front seat mounting bracket to the gas tanks
using a 1/2” socket.
3.4.
Raise front axle and safely secure with jack
stands. This will minimize the amount of hydrau-
lic fluid in the pump.
3.5.
Remove the spring from the ferrule on the drive
control rod.
3.6.
Remove the hairpin from the ferrule on the drive
rod.
Figure 3.3
Screws
Fuel tank
Figure 3.6
Drive Control
Rod
Ferrule