Transmission removal, Series 5000 – Cub Cadet 5000 Series User Manual
Page 13
Advertising
Series 5000
9
3.11. Inspect the O rings (seal glands) around the
PTO shaft opening and the transmission drive
spiral bevel gear opening located on the front of
the transmission housing.
3.12. Inspect the mating surface on the back side of
the pump.
Figure 3.11
Seal
PTO Shaft
Seal
Transmission
Drive
Figure 3.12
Mating
Surface
4.
TRANSMISSION REMOVAL
4.1.
Remove the fender, floor and ROPs.
4.2.
Disconnect the fuel level sensor wires from the
top of the fuel tank.
4.3.
Clamp and disconnect the fuel line from the fuel
tank.
Figure 4.2
Fuel
Sensor
Figure 4.3
Fuel Line
Advertising