Series 5000 – Cub Cadet 5000 Series User Manual
Page 16
Series 5000
12
4.17. Disconnect the hydraulic line running from the
front of the auxiliary pump to the steering pump
using a 1” wrench and a 1 1/16” wrench.
4.18. OPTIONAL: Remove lift cylinder.
4.19. Remove the self tapping screw securing the tab
on the lift cylinder pin to the lift cylinder mounting
bracket.
4.20. Slide the pin out of the cylinder and bracket
while removing the cylinder.
4.21. Place the tractor in neutral.
4.22. Remove the hairpin that connects the high / low
actuator shaft to the high / low pivot link.
4.23. Remove the bellcrank from the frame using a 1/
2” socket and a 5/8” wrench.
NOTE: Upon assembly, the bell crank is
installed with the larger hole (mounting hole to
frame) positioned towards the outside and rear
of the transmission.
Figure 4.17
Auxiliary Pump
Hydraulic line
from auxiliary
pump to
steering pump
Figure 4.19
Screw securing
lift cylinder tab
Lift
Cylinder
Figure 4.20
Cylinder mounting
bracket
Pin
Figure 4.23
Bell
Crank
Nut and Bolt
securing bell
crank
to frame