Freerider FR168-4P(Richmond 4) - Manual (Page 22)

22
CHARGER FAULT INDICATIONS
SYMPTOMS POSSIBLE CAUSE SUGGESTED ACTION
Red mains on indicator will not
illuminate when charger supply
switched on
Replace fuse with identical type
Replace fuse with identical type
Switch supply on
Check supply present with another appliance
Return Charger for repair
Indicator lights No 2 (yellow]
and No 4 (green] flashing
alternately Possible battery fault Have batteries tested by
Freerider Service Agent
Indicator light No 4 (green]
pulsing Switch off charger and check battery voltage
Deeply discharged batteries may require special
attention for recovery
With red indicator light on
and indicator lights Nos 2, 3
& 4 flashing continuously
Check battery wiring looms are correctly
connected to positive and negative terminals
Check battery connecting plugs are in place
Indicator light No 2 (yellow]
flashing
Mains plug fuse 5A failed
Charger T2A fuse located rear of case
Charger supply not switched on
Mains supply not present
Charger fault
This indicates that the overall charge timer has
operated
Battery voltage is too low for Charger to
operate (below 6 volts in each battery] charger
output inhibited
Reverse polarity
No battery connection
Safety overload protection inside charger has
tripped
Possible Charger fault Switch off Charger
Return Charger for repair
ADVISORY NOTES
1 Disconnect from the mains supply before removing the 3-pin
charge plug from the charge socket
2 Do not cover the side and rear ventilation slots of the
Charger Failure to observe this warning could result in
overheating of the Charger
3 The Richmond Charger is for indoor use only: DO NOT
EXPOSE TO RAIN OR MOISTURE.
4 Do not smoke or use naked flame near your batteries while
they are being charged
5 Do not use an extension lead unless absolutely necessary
Use of an improper extension lead could result in a risk of
fire and electric shock
6 Do not use the Charger if it has received a sharp blow, been
dropped or otherwise mis-used in anyway Return Charger to
your Authorised Freerider Agent
7 Do not dismantle the Charger, poke or drop objects through
the slots in the Charger case
8 Do not switch off, unplug or interrupt the re-charge cycle
until the charging cycle has completed Failure to observe
this instruction can result in overcharging of the batteries
9 There is a drive inhibit function on your Scooter. The
Scooter cannot be driven when the Charger is plugged
into your FR168-3P/4P.
Y OUR GUIDE TO SAFE AND
LASTING BATTERIES
1 For longest life, your batteries should be re-charged after
use Preferably over night
2 If your Scooter is not used for a period of time, a
refreshing charge should be given every month Never leave
your batteries in a discharged condition This is particularly
important with sealed batteries as fitted to your
Scooter
If your batteries discharge below a total terminal voltage of
12 volts (6 volts per battery], the charger supplied with
your Scooter will not operate Please consult your
Freerider dealer
3 If your Scooter has been stored away for some time, re-
charge your batteries before re-using it
4  Every six months, check the connections on the
batteries, making sure they are tight and clean, make certain
the red / black terminal covers are maintained
5 Batteries carry a limited guarantee from the original
manufacturer which is subject to a stringent wear and
tear clause. Any battery faults due to a defect in the
original manufacture will normally become obvious
within the first two months. Any gradual deterioration
in performance after this period is normally associated
with fair wear and tear, mis-use or accidental damage
and, as such, is not covered by the manufacturer’s
warranty. (This does not affect your statutory rights).
Note: If one battery becomes faulty during the guarantee
period only that battery from the pair will be replaced