Freerider FR168-4P(Richmond 4) - Manual (Page 32)

32
SET-UP MENU DESCRIPTION SETTINGS
Acceleration 3
Deceleration 8
Forward Speed 10
Reverse Speed 5
Reduce Speed 4
Buzzer Volume 10
Motor Resistance 60
Sleep Time 15
Maximum Current 70
Park Brake Delay 4
OPTION MENU DESCRIPTION SETTINGS
Single-Ended Pot OFF
Standard Speed Pot OFF
Motor Reverse OFF
Pot Reverse OFF
Brake Checking ON
Load Compensation ON
Enable Sleep ON
Check for Slope OFF
Current Limit Timer ON
STATUS FAULT CODES
FLASH CODE FAULT DISPLAYED
(No. of flashes) BY PROGRAMMER
FREERIDER SCOOTER
CONDITION COMMENT
1 Flash Driving still possible The battery voltage has dropped below 23 3 volts in neutral
Recharge the batteries soon
2 Flashes Drive inhibited The battery voltage at Controller has dropped to 16 5 volts
Check the battery condition and the connections
3 Flashes Drive inhibited The battery voltage at the controller is greater the 32 volts
Check the battery condition and the connections Suspect a
charger malfunction
4 Flashes Drive inhibited The Controller has detected a shorted or overworked motor
Check the loom for shorts or check out the motor Contact your
Service Agent
5 Flashes Drive inhibited Check the Freewheel Lever is fully engaged Check the Park Brake
and wiring for open or short circuits Contact your Service Agent
6 Flashes Drive inhibited Drive possible if neutral
selected within 10 secs Return the speed lever to neutral Re-adjust the speed lever
neutral if necessary Consult your Service Agent
7 Flashes Drive inhibited Check speed pot wiring for open or short circuits Speed pot
may not be correctly set up Contact your Service Agent
8 Flashes Drive inhibited Motor or wiring is faulty Contact your Service Agent
Battery needs recharging
Battery voltage too low
Battery voltage too high
Current limit time out
Brake fault
Out of neutral when power
switched on at key switch
Speed pot error
(wig wag]
Motor volts error
Other internal errors Drive inhibited Contact your Service Agent 9 Flashes
SPEED CONTROLLER SETTINGS
The forward-reverse speed Controller (Fig 37 page 30] is a
state-of-the-art microprocessor designed to give smooth and
safe operation For maximum performance, protection and
convenience the Controller is housed in a solid die cast
aluminium case situated under the rear body cover
The speed Controller, ‘Dynamic’ model DS72KO1(Rhino] is
programmed by Freerider to obtain the maximum performance
and safety for your Scooter
Warning: Performance adjustments should not be made which
could put the operator in a serious situation of control or
braking Performance adjustments should only be made by a
person fully trained and conversant with the programming
process and it’s capabilities
Warning: Incorrect settings could cause injury to the Scooter
operator and/or to bystanders, or damage to the vehicle
and/or surrounding property If in doubt consult your
Freerider Manufacturer
The original manufacturer’s settings for this Scooter are: