FRITSCH PULVERISETTE 7 classic line - Manual (Page 16)

5. To save and exit setup mode, press the STOP button.
2.7 Hazardous points
CAUTION!
– Crushing hazard when closing the hood (3).
– Crushing hazard at the spindle clamping device (5).
2.8 Electrical safety
2.8.1 General information
n The main switch (8) separates the device from the mains on two
poles.
n Switch off the main switch (8) if the planetary micro mill will be idle
for an extended period of time (e.g. overnight).
2.8.2 Protection against restart
If a power failure occurs during operation or if the device is switched off
with the main switch (8), the hood (3) is locked. The hood lock (6) is
automatically released when the power returns. For safety reasons, how-
ever, the mill does not restart.
2.8.3 Overload protection
n In the event of an overload, the device reduces the speed in a con-
trolled manner. The REDUCED SPEED light is lit as a warning. The
device can be used again with the reduced speed.
n The device switches off if the drive motor becomes too hot.
n The device switches off if the drive is blocked. (See Ä Chapter 9
‘Repairs’ on page 45)
Safety information and use
- 16 -